Blog

Gearbox Breather Clogging – Filter Barrels

Breathers are an important function of any gearbox. They allow heat to escape and cooling air to enter the system, preventing unnecessary overheating issues. Gearboxes that do face overheating issues will cause other problems to occur, such as an increase in viscosity, a higher viscosity will cause accelerated wear by losing its ability to lubricate…
Read more

OnSpec Fuel Conditioning and Purging (update)

Results on the Mitsubishi Canter have come back at an 8% reduction, our estimates where very close at 7%. Not only have we seen an improvement on fuel reduction but also on the Oil Analysis results, the last analysis results have shown lower soot, oxidation, Iron and PQ90 levels, this is impressive, not only will…
Read more

Tractor Engine Saved

I'm so happy, we saved a farmers tractor engine. Greg McNaught a local farmer rang Lisa in desperation with a sample of engine oil from a cat tractor. The oil pressure kept dropping and he was worried and concerned about blowing up an engine. At Techenomics we are very focused on providing accurate and timely…
Read more

OnSpec Fuel Conditioning and Purging (update)

Today Darrin drove the truck out to Muswellbrook, that’s approximately 47klm, he noticed an increase in power immediately, Darrin words where “Its like it has two Engines -  it runs smoother then before, the gear changes are smoother, its quieter, over all just a far better vehicle to drive than before”  Now we are just…
Read more

OnSpec Fuel Conditioner and Purging

Today Darrin, Adrian and I purged the Mitsubishi Canter, while Darrin and I arranged the setup and purging of the truck, Adrian video recorded the whole event, this will later be edited and uploaded to  YouTube, the whole event was very successful with the Truck firstly blowing black smoke on startup and when it was…
Read more